Претраживање
Приказ резултата 521-530 од 558
Prostorna interpretacija Hugelschaffer-ove konstrukcije jajaste krive
(Niš: Faculty of Architecture and Civil Engineering in Niš; Serbian Society for Geometry and Graphics (SUGIG), 2008)
Konstrukcija jajaste kubne krive Hügelschäffer-ovom metodom, zasniva se na konstrukciji elipse metodom koncentričnih krugova različitih radijusa, a i b, koji odgovaraju parametrima elipse. Načinjen je pokušaj da se prostornom ...
Static calculation of stabilization of the landslide in cut 4 from km 878+650 to km 879+050
(7th International conference ''Contemporary achievements in civil engineering'', 23-24. April 2019. Subotica, 2019)
The paper presents retaining structure to stabilize the landslide in the middle
section from 878+775 to km 878+825, and slope protection on both left and right sides
in order to provide vertical cutting and excavation ...
Conic Section of a Type of Egg Curve Based Conoid
(Belgrade: Faculty of Architecture in Belgrade; Serbian Society for Geometry and Graphics (SUGIG), 2010)
A cubic egg curve obtained by Hügelschäffer’s construction,
can be spatially interpreted as a plane section of a type of a conoid
set through a specially chosen 4-th order intersecting curve of two
quadrics: right ...
Experimental Investigation and Numerical Analysis of the Axial Load Capacity of Circular Concrete-Filled Tubular Columns
(MDPI, 2024)
This paper focuses on the experimental investigation of the axial load capacity of CFT
(concrete-filled steel tube) columns under actual construction conditions during building reconstruction. A total of four samples were ...
Bearing capacity calculation for middle slender and slender CFT circular columns
(Univerzitet u Novom Sadu Građevinski fakultet Subotica, 2017)
In middle slender and slender CFT columns the loss of capacity is based on
the problem of stability. In this case, we must take into account the effects of the second
order. A nonlinear model was created in computer ...
A Comparative Study of ML and FEM Models for the Prediction of Seismic Structural Behavior
(International Conference Natural Resources and Environmental Risks: Towards a Sustainable Future, Building of Branch of the Serbian Academy of Sciences and Arts in Novi Sad, Serbia, 2023)
During the last several decades, the finite element method (FEM) is the most commonly used numerical method for performing seismic structural analysis. It requires careful structural modeling, but also the adjustment of ...
Transverse vibration of plate with edge beams using spectral element method
(Proceeding 4th International Congress of Serbian Society of Mechanics, 2013)
The development of the dynamic stiffness matrix of rectangular plate with symmetrically distributed
edge beams using Spectral Element Method (SEM) has been presented in this paper. It is assumed that beams are
ideally ...
Konstruktivna obrada hiperboličke spirale kao centralne projekcije cilindrične zavojnice
(Novi Sad: Fakultet tehničkih nauka, 2006)
Centralna projekcija cilindrične zavojnice jeste ravna transcedentna kriva, u najopštijem slučaju. U određenim slučajevima, ta kriva će biti upravo spiralna kriva. U specijalnom slučaju, kada se osovina cilindra poklapa ...
Numerički postupak za određivanje stanja deformacija i napona u AB presecima
(Društvo građevinskih konstruktera Srbije, 2022)
U radu je dat predlog jednog numeričkog postupka za određivanje stanja deformacija i napona u armiranobetonskim presecima. Postupak se zasniva na MKE sa korišćenjem “fiber“ elemenata. Za predložene veze napona i deformacija ...
Landslide stabilization in cut zone number 6 from km 28 + 478,00 to km 28 + 643,00
(8th International conference ''Contemporary achievements in civil engineering'', 22-23. April 2021. Subotica, 2021)
In the cut zone number 6 on E-80 Niš-Dimitrovgrad highway from km 28 +
478,00 to km 28 + 643,00 slope stability was affected causing mass movement. Additional
inclinometers measured the mass wasting thickness between 14 ...