Претраживање
Приказ резултата 1-10 од 56
Furthering knowledge on the flow pattern around high-rise buildings: LES investigation of the wind energy potential
(Elsevier, 2022)
To understand the favourable locations for maximum yield of urban wind energy, understanding the flow pattern on the roof region of high-rise buildings is crucial. However, very few studies in the literature report on the ...
Potential of Natural and Recycled Concrete Aggregate Mixtures for Use in Pavement Structures
(MDPI, 2020)
This study investigates the feasibility of using recycled concrete aggregate (RCA) as a partial substitution of natural aggregate in pavement engineering. Despite RCA’s good properties, such as polishing value and freeze-thaw ...
Design procedures for cold-formed stainless steel equal-leg angle columns
(Thin-Walled Structures, 2020)
Currently, there is still no explicit design approach for cold-formed stainless steel columns with equal-leg angle sections in Europe. A comprehensive numerical investigation, validated by the available experiments collected ...
Recommendation of RILEM TC 264 RAP on the evaluation of asphalt recycling agents for hot mix asphalt
(Springer, 2022)
This recommendation is based on the results of an inter-laboratory study organised by the RILEM technical committee TC 264-RAP "Asphalt Pavement Recycling"—Task Group 3 (TG3) focusing on Asphalt Binder for Recycled Asphalt ...
Planning and Suitability Assessment of Large-scale Nature-based Solutions for Flood-risk Reduction
(Water Resources Management, 2021)
Adverse effects of climate change are increasing around the world and the floods are
posing significant challenges for water managers. With climate projections showing
increased risks of storms and extreme precipitation, ...
Column Curves for Stainless Steel Lipped–Channel Sections
(Journal of Structural Engineering, 2020)
The strength of thin-walled stainless steel columns has been investigated extensively over the last few years. The present paper presents the results of an extensive computational study of the buckling strength of ...
Behaviour of stainless steel plain channel section columns
(Thin-Walled Structures, 2020)
In this paper, the structural stability of cold-formed stainless steel plain channel columns under axial compression is investigated. Reliable finite element models for channel section columns are first ...
Weighted P-partitions enumerator
(Applicable Analysis and Discrete Mathematics, 2021)
To an extended generalized permutohedron we associate the weighted integer points enumerator, whose principal specialization is the f-polynomial. In the case of poset cones it refines Gessel's P-partitions enumerator. We ...
Experimental response of hot-rolled stainless steel angle columns
(Thin-Walled Structures, 2021)
This paper reports on experiments addressing the buckling and collapse behaviour of pin-ended hot-rolled stainless steel equal-leg angle columns under pure axial compression, aiming to provide reliable experimental data ...
Experimental study of laser-welded stainless steel angle columns
(Thin-Walled Structures, 2021)
Substantial research has been conducted in the last years into the structural responses of cold-formed and hot-rolled stainless steel equal-leg angle columns, whereas there is no experimental data on laser-welded stainless ...