Pretraživanje
Prikaz rezultata 2171-2180 od 2201
Contaminant Build-Up in Urban Snow Cover
(Water Research and Management, 2017)
Evaluating the transferability of monthly water balance models under changing climate conditions
(Taylor&Francis, 2020)
Monthly water balance models (MWBMs) are often used for making flow projections under climate change. As such, these models should provide accurate flow simulations; however, they are seldom evaluated in this regard. This ...
Municipal wastewater treatment in republic of Serbia: Present state and the perspectives / Prečišćavanje gradskih otpadnih voda u Republici Srbiji - stanje i perspektive
(Savez građevinskih inženjera Srbije, Beograd, 2010)
This paper presents an overview of municipal wastewater and sludge treatment methods. Procedure for determination of input wastewater loads has been described, as well as requirements that should be fulfilled to establish ...
Wheel/rail noise control / Kontrola buke u dodiru točka i šine
(Naučno-stručno društvo za zaštitu životne sredine Srbije - Ecologica, Beograd, 2011)
This paper analyzes the relation between wheel and rail induced noise regarding the reduction in the total noise emission. Priorities are defined for reduction of noise emission from wheel and rail. It is also pointed out ...
Impact of calibration period on parameter estimates in the conceptual hydrologic models of various structures / Утицај периода калибрације на оцене параметара концептуалних хидролошких модела различитих структура
(Универзитет у Београду, Грађевински факултет, 2015)
Conceptual hydrologic models are commonly applied for flow forecasting, estimation ofdesign flows and assessment of climate change impact on water resources. Therefore,reliability of hydrologic simulations obtained by ...
Evaluation of methods for predicting axial capacity of jacked-in and driven piles in cohesive soils
(Union of Croatian Civil Engineers and Technicians, 2018)
This paper presents the evaluation of methods for predicting the ultimate axial bearing capacity of single piles based on the cone penetration test (CPT) results, and the evaluation of static methods based on the effective ...
Geometrically Nonlinear Analysis of Composite Plates Using Layerwise Displacement Model
(Faculty of Engineering, University of Porto, Portugal, 2011)
The low mass density and the high tensile strength, usually expressed through the specific modulus of elasticity and the specific strength, have made composite materials lighter and stronger compared with most traditional ...
Contaminant buildup and distribution on urban impervious surfaces at parking lots
(Serbian Water Pollution Control Society, Belgrade, 2015)
This paper presents the results of experimental investigations on contaminant buildup, distribution and dynamics on asphalt surfaces of parking lot in Belgrade, Serbia. The investigated pollutants were solids, nutrients, ...
Determination of dynamic thermal characteristics of a building wall
(Mechanical Engineering Faculty, University of Niš, 2015)
In this paper, based on in situ experimental temperature measurements, the following dynamic thermal parameters of a wall were calculated: decrement factor, time shift of thermal transmittance and areal heat capacities. ...
Calibration of the high strenght bolts for measuring of the pretension force
(International Conference on ADVANCES IN STEEL STRUCTURES, Lisbon, Portugal, July 22-24, 2015., 2015)
When analysing slip resistance connections, which are commonly used in-situ assemblied joints of structures dominantly loaded by cyclic loading, for example in bridges, telecommunication towers, towers for wind turbines, ...