Претраживање
Приказ резултата 11-20 од 32
Integrated hydrological information system for northern Algeria
(IAHS-AISH Publication, 2010)
As a result of cooperative work of experts from Algeria (ANRH) and Serbia (Energoprojekt with the assistance of Belgrade University) through the project CRESNA (Carte des Ressources en Eau Souterraines du Nord de l'Algerie), ...
The Mean Stress as the Governing Parameter in the Implicit GPM Stress Integration of Modified Cam-Clay Model
(Information Technology in Geo-Engineering, 2010)
An implicit computational governing parameter method (GPM) for stress integration of the modified Cam-Clay model is presented in the paper. In the previous studies, the increment of the mean plastic strain d epsilon(p)(m) ...
Numerical modeling of dissolved oxygen recovery during aeration in lakes
(Environmental Hydraulics - Proceedings of the 6th International Symposium on Environmental Hydraulic, 2010)
One of available lake restoration technologies is injection of compressed air or oxygen into a hypolimnion, promoting vertical mixing of water and dissolution of oxygen.A numerical model has been developed for simulation ...
Dinamička krutost pravougaonog temelja
(13. Kongres Društva građevinskih konstruktera Srbije - DGKS, 2010)
U dinamiþkoj analizi interakcije tla i objekta u frekventnom domenu, primenom metode podstruktura, uticaj tla se zamenjuje dinamiþkom matricom krutosti. Elementi te matrice su kompleksne, frekventno zavisne funkcije, koje ...
Defining the principal axes of the quadric cone - a general case with elliptic base section curve
(Faculty of Architecture, University of BelgradeSerbian Society for Geometry and Graphics, 2010)
This paper presents an constructive procedure of determining three mutually orthogonal principal axes (three planes of symmetry) of the quadric cone, the general case with elliptical base section curve.The constructive ...
Identification of leak characteristics in pipe systems by dynamic monitoring
(Integrating Water Systems - Proceedings of the 10th International on Computing and Control for the W, 2010)
The paper presents some reflections about use of hydraulic transients in identification of pipe system characteristics. Controlled and safe transients can be used to excite pipe network to respond to change in flows/pressures. ...
Nosivost na smicanje anker ploče sa grupom elastičnih čep moždanika
(Internacionalni naučno-stručni skup Građevinarstvo - nauka i praksa 2010, 15-19. februar 2010, Žabljak, Podgorica, knjiga 1, 2010)
Joint between concrete structural member and steel or timber structural member can be realized with anchor plate which is being embeded in concrete structure during the erection. Anchor plate can be connected with concrete ...
Seminary paper as an additional task in teaching descriptive geometry
(Faculty of Architecture, University of BelgradeSerbian Society for Geometry and Graphics, 2010)
As a result of introducing Bologna process in education, classes of Descriptive geometry were reduced. In order to acquire such a complex matter as Descriptive geometry, it was necessary to provide an additional task as ...
Conic Section of a Type of Egg Curve Based Conoid
(Belgrade: Faculty of Architecture in Belgrade; Serbian Society for Geometry and Graphics (SUGIG), 2010)
A cubic egg curve obtained by Hügelschäffer’s construction,
can be spatially interpreted as a plane section of a type of a conoid
set through a specially chosen 4-th order intersecting curve of two
quadrics: right ...
Vibrational behaviour of timber floors
(11th World Conference on Timber Engineering 2010, WCTE 2010, 2010)
A complete design methodology for timber floors must address the problem of annoying vibration caused by the occupants themselves. Proper controlling relies on good understanding nature of floor vibrations induced by human ...