Pretraživanje
Prikaz rezultata 11-20 od 66
The Influence of Accelerated Carbonation on Physical and Mechanical Properties of Hemp-Fibre-Reinforced Alkali-Activated Fly Ash and Fly Ash/Slag Mortars
(MDPI, 2022)
The physical and mechanical properties of hemp-fibre-reinforced alkali-activated (AA) mortars under accelerated carbonation were evaluated. Two matrices of different physical and chemical properties, i.e., a low Ca-containing ...
Span-to-depth ratio limits for deflection control of reinforced concrete elements
(Structural Concrete, 2022)
Indirect deflection control usually applies the limitation of the span-to-depth
ratio. The procedures that have developed in the past decades have mostly
been derived for predefined values of some of the relevant parameters. ...
Procena stanja temeljnih konstrukcija turbo-generatora blokova A1 i A2 termo elektrane „Nikola Tesla“
(Savez građevinskih inženjera Srbije / Association of Civil Engineers of Serbia Beograd, Kneza Miloša 9/I, 2022)
U radu je prikazana metodologija koja je primenjena kod kontrolnih proračuna dva
armiranobetonska turbo-stola termoelektrane „Nikola Tesla“ u Obrenovcu. Proračuni su rađeni sa
ciljem utvrđivanja stanja konstrukcija nakon ...
Influence of cracks on the deterioration mechanisms and durability of reinforced concrete structures
(Association of Structural Engineers of Serbia, 2022)
The most important factor that affects concrete deterioration is the appearance of cracks on reinforced concrete (RC) structures, so the influence of loading cracks should not be neglected when the service life is analyzed. ...
Strain measurements during static pile testing: a case study of two piles with diferent diameter and length
(the 8th international conference "civil engineering – science and practice", GNP 2022 – Kolašin, Montenegro, 8-12 March, 2022)
The paper presents testing of two piles, diameter of Ø1200mm and Ø800mm, length of 26.0m
and 18.0m respectively. Tests were conducted on construction project WELLPORT III phase -
New Belgrade, Republic of Serbia. The ...
Modal analysis of the suspension footbridge over river Vrbas in Banja Luka
(The 8th international conference "civil engineering – science and practice", Kolašin, Montenegro, 8-12 March, 2022)
When evaluating modal properties of lively structures as footbridges, numerical modelling
should be used with caution. This is due to model uncertainties mostly related to material
parameters, boundary conditions, the ...
Resistance of different types of stainless steel equal angles under axial compression
(Univerzitet u Beogradu Građevinski fakultetDruštvo građevinskih konstruktera Srbije, 2022)
U važećem evropskom standardu SRPS EN 1993-1-4 nisu eksplicitno definisana pravila za proračun centrično pritisnutih elemenata ravnokrakog L poprečnog preseka od nerđajućeg čelika. Ovaj rad ukratko prikazuje rezultate ...
Environment Protection – International Regulation
(Union of Mechanical and Electrotechnical Engineers and Technicians of Serbia (SMEITS) Society for Renewable Electrical Power Sources, 2022)
In this article, the authors analyze phases of the development of international environmental law, stating the main features of each, and the relevant international instruments adopted in this area. Special emphasis is put ...
Investigation of the mechanical, hydrophysical and thermotechnical properties of porous lightweight aggregate concrete
(Društvo za ispitivanje i istraživanje materijala i konstrukcija Srbije I Udruženje savremene industrije glinenih proizvoda Srbije, 2022)
The results of comparative testing of porous lightweight aggregate concrete made with various percentages of neutral as a partial replacement of cement are presented in this paper. Neutral represents non-hazardous, inert ...
The effect of thermal treatment on mechanical and deformation properties of steel reinforcement
(University of Banja Luka, Faculty of Architecture, Civil Engineering and Geodesy, 2022)
Presented research was intentioned to clarify the effects of thermal treatment (ageing) of reinforcing steel products on their mechanical and deformation properties. In order to determine the effect of temperature, samples ...