Претраживање
Приказ резултата 11-20 од 28
Effect of accelerated carbonation on the efficiency of immobilization of Cs in the alkaliactivated blast furnace slag
(Slovenian National Building and Civil Engineering Institute (ZAG), 2021)
In this paper the effect of accelerated carbonation process on the effectiveness of immobilization of cesium (simulated radioactive and toxic waste) in the alkali-activated blast furnace slag (AABFS) matrix was studied. ...
Dynamic behavior of a cable-stayed footbridge over river Vrbas in Banja Luka
(University of Banja Luka Faculty of Architecture, Civil Engineering and Geodesy, 2020)
This paper presents a dynamic behavior analysis of an old cable-stayed footbridge over river Vrbas in Banja Luka. Identification of modal parameters, of this prone to vibrations footbridge structure, was performed using ...
A numerical verification of IPE-80 steel cantilever beam with bolted and welded splice connection joint
(THE 7th INTERNATIONAL CONFERENCE "CIVIL ENGINEERING - SCIENCE AND PRACTICE" GNP 2020 – Kolašin, Montenegro, 2020)
The aim of this paper is to discuss numerical analysis and verification of experimentally tested bolted and weld splice connections in the commercial Abaqus software. The first step in verifying a numerical model with an ...
Modal properties of the old suspension footbridge based on ambient vibration measurements
(THE 7th INTERNATIONAL CONFERENCE "CIVIL ENGINEERING - SCIENCE AND PRACTICE" GNP 2020 – Kolašin, Montenegro, 2020)
The paper presents study of dynamic properties estimation based on ambient vibration measurements of the old suspension footbridge over the river Vrbas in Banja Luka (in Šeher sub-area), Serbian Republic in Bosnia. Prone ...
Numerical modelling of end-notched glulam beams reinforced with GFRP bars
(Centro UC de Innovacion en Madera, 2021)
Load carrying capacity of end-notched timber beams can be significantly decreased depending on the geometry of notches. Concentration of tensile stresses perpendicular to grain and shear stresses at the notch corner can ...
Imperfection sensitivity study of hot-rolled and laser-welded stainless steel angle columns
(Ernst&Sohn, 2021)
Stainless steel sections are used for structures in aggressive environments where the greater material cost can often be justified in return for longer maintenance-free periods, for example in the water treatment, ...
Steel Structure Prediction Model for Fixed Roof Oil Tanks
(Wiley / Ernst & Sohn GmbH, 2021)
This paper will focus on fixed roof storage tanks and its sub-category cone roof tanks. Paper presents major factors and outputs of tank design process. Theoretical analysis is done for a cone roof tank model and correlation ...
Influence of Cracks on the Carbonation Resistance of Recycled Aggregate Concrete
(Fib, 2021)
The use of recycled concrete aggregate (RCA) for the production of new concrete can be a promising eco-efficient solution. However, replacement of natural aggregate (NA) with RCA influences concrete’s durability performance. ...
Thick Resistive Film Application on Steel Bars for Structural Health Monitoring
(Electron Devices Society of the Institute of electrical and electronics engineers, inc., 2023)
This paper aims to examine the applicability of thick-film piezo-resistive sensors on steel bars for the structural health monitoring purposes. A thick film ceramic piezo-resistive sensor was manufactured and used to ...
Physical and mechanical properties of Ultra-high- performance concrete with limestone
(Macedonian Association of Structural Engineers, 2022)
The production of ultra-high performance concrete is one of the new ideas in modern construction, developed in the past few decades. A compressive strength higher than 150 MPa has been achieved using a relatively large ...