Pretraživanje
Prikaz rezultata 1-10 od 39
Concrete modeling in finite element push-out test simulations
(MASE - Macedonian Association of Structural Engineers, Skopje, 2023)
Push-out tests are commonly used to investigate the shear performance of mechanical connectors
applicable in steel-concrete composite beams. These tests can be complemented by numerical finite element simulations to reduce ...
Behaviour and design of bolted connectors with mechanical coupler: an overview
(Proceedings of the 20th International Symposium of the Macedonian Association of Structural Engineers (MASE), Skopje, September 28-29, 2023., 2023)
The construction industry is one of the most important parts of economic development of society but it
also has a very negative impact on the environment. Using the three concepts of circular economy: reuse,
reduce and ...
Hardened properties of 3D printed concrete - experimental investigation
(Macedonian Association of Structural Engineers, 2023)
At the end of the last century, 3D printing of concrete became an innovative method for producing
concrete structures. The beginning of the application of 3D printing in the concrete construction industry is referred to ...
Cathode Ray Tube Waste Glass in Concrete Preparation - Increasing Sustainability
(Union of Mechanical and Electrotechnical Engineers and Technicians of Serbia (SMEITS) Society for Renewable Electrical Power Sources Kneza Miloša str. 7a/II, 11000 Beograd, 2023)
The construction sector is responsible for approximately 39% of energy use and process-related carbon dioxide emissions. Mixing waste materials into concrete, as a substitute for cement
and/or aggregate, increases energy ...
Local behaviour of the connector with mechanical coupler and rebar anchor under tension load
(Society for Materials and Structures Testing of Serbia; Faculty of Civil Engineering, University of Belgrade, Serbia; Association of Structural Engineers of Serbia, 2023)
In the past few decades, demountable connectors have often been used for
connections in composite and mixed steel-concrete structures to reduce
construction time and costs. Furthermore, the application of demountable
connectors ...
Residential Building Stock in Serbia: Classification and Vulnerability for Seismic Risk Studies
(Bulletin of Earthquake Engineering, 2023)
Regional seismic risk assessment is necessary for designing effective seismic risk mitigation measures. In general, such risk assessment studies consist of three components: hazard, vulnerability, and exposure modelling. ...
Service Life Design of Concrete Structures Made of High-Volume Limestone Powder Concrete—Case of the Carbonation-Induced Corrosion
(MDPI, Basel, Switzerland, 2023)
One of the paths to CO2 emissions reduction in the concrete industry is to use low-clinker cements, providing at the same time the performance of concrete that is adequate for application in concrete structures. This paper ...
Utilization of solidified industrial hazardous waste in construction: A case study
(ACHE Publishing, 2023)
Utilization possibilities of solidified fractions of industrial hazardous waste obtained by mixing
with inert materials in construction were investigated. Waste mineral oils, water-hydrocarbon
emulsions mixture, and waste ...
Contribution of strain-hardening cementitious composites (SHCC) to shear resistance in hybrid reinforced concrete beams
(Faculty of Civil Engineering, University of BelgradeSociety for Materials and Structures Testing of SerbiaAssociation of Structural Engineers of Serbia, 2023)
Strain Hardening Cementitious Composite (SHCC) is an innovative type of fibrereinforced
cement-based composite that has superior tensile properties. Because
of this, it holds the potential to enhance the shear capacity ...