Pretraživanje
Prikaz rezultata 1-10 od 14
THREE-DIMENSIONAL STRESS ANALYSIS OF LAMINATED COMPOSITE PLATES USING FLWT-BASED FINITE ELEMENTS
(Proceedings / The 7th International Congress of Serbian Society of Mechanics, Sremski Karlovci, June 24-26, 2019, 2019)
The paper deals with the 3-D stress analysis of laminated composite plates using a layerwise
displacement model of Reddy, that assumes piece-wise linear variation of all displacement
components and the quadratic variation ...
Free vibration analysis of multiple cracked frames using dynamic stiffness method
(Proceedings / The 7th International Congress of Serbian Society of Mechanics, Sremski Karlovci, June 24-26, 2019, 2019, 2019)
Cracks are the most common type of structural damage in many engineering structures,
introducing the local change in stiffness of structural elements and changing the dynamic
properties of the structure. Therefore, it ...
Finite Element Model of Imperfect Plate in Thermal Environment
(Serbian Society of Mechanics, Belgrade, 2019, 2019)
In this paper a finite element model for thermal buckling of imperfect plates using Layer Wise (LW) plate mode [1] is presented. The model assumes layerwise variation of in-plane displacements and constant transverse ...
Design of 120m guyed steel mast in Alibunar according to Eurocode
(MASE - Macedonian Association of Structural Engineers, 2019)
Guyed masts are slender tall structures widely used to support different kinds of antennas in telecommunications. They consist of a vertical tall mast laterally supported at several levels along its height by sets of ...
Comparison of different methods for viscoelastic analysis of composite beams
(Serbian Society of Mechanics, 2019)
The paper presents and compares four methods for visco-elastic analysis of steel-concrete composite beams. The method denoted as "exact" is based on the use of linear integro-differential operators and besides inevitable ...
Pressure field analyses of a low-rise building model surrounded by neighbouring buildings in urban areas
(Serbian Society of Mechanics, 2019)
In this paper, pressure field over the roof of low-rise building model has been investigating using numerical simulations. The model is surrounded by four neighboring buildings of the same geometry as the principle one. ...
Experimental testing of axial load capacity and stability of circular CFT columns
(Serbian Society of Mechanics, 2019)
The paper presents the experimental testing of the axial capacity and stability of short,
moderately slender and slender circular CFT columns. For the purpose of sample testing a special
set of hydraulic presses was ...
Application of green roof for increasing the energy efficiency of the existing building in Belgrade
(Serbian Union of Mechanical and Electrical Engineering (SMEITS), 2019)
This paper presents the analysis of the potential use of green roofs to enhance the energy efficiency of the residential buildings. Namely, in urban areas, there is a lot of potential for reducing the energy needed for ...
Experimental investigation of wind load on low-rise industrial building
(Faculty of Civil Engineering Subotica, 2019)
Aim of this paper is to investigate wind pressure distribution on low-rise industrial
building based on the results from atmospheric boundary layer wind tunnel experiments.
Building model is a hanger with a tilted roof ...
Traditional materials as a solution to construction in the new age of climate distrubances
(Faculty Of Civil Engineering Subotica, 2019)
The paper contains the authors’ experiences and findings that were yielded as a result of measurements of the thermodynamic properties of traditional renewable materials. As a testament to the quality of existing traditional ...