Претраживање
Приказ резултата 1-10 од 407
In-plane free vibration and response analysis of isotropic rectangular plates using the dynamic stiffness method
(Elsevier Ltd, 2015)
The development of the dynamic stiffness matrix for isotropic rectangular plate with arbitrary boundary conditions undergoing in-plane free vibration is presented in this paper. Gorman's superposition method is exploited ...
The 3DNet-Catch hydrologic model: Development and evaluation
(Elsevier B.V., 2019)
Hydrologic models are important for effective water resources management. They vary in complexity from parsimonious, spatially lumped, to physically-based, fully distributed models, which are generally expected to outperform ...
Intensity Fiber-Optic Sensor for Structural Health Monitoring Calibrated by Impact Tester
(Institute of Electrical and Electronics Engineers Inc., 2016)
In this paper, the use of intrinsic intensity fiber-optic sensors for structural health monitoring was investigated. Polyethylene-based composite samples with glass mat reinforcement and embedded telecommunication fibers ...
Planning and Suitability Assessment of Large-scale Nature-based Solutions for Flood-risk Reduction
(Water Resources Management, 2021)
Adverse effects of climate change are increasing around the world and the floods are
posing significant challenges for water managers. With climate projections showing
increased risks of storms and extreme precipitation, ...
Absolute Time Series GNSS Point Positioning-Data Cleaning and Noise Characterization
(Strojarski fakultet u Slavonskom Brodu, 2020)
Time series data of GNSS point positioning are considerably used for the purpose of geophysical research. The velocity estimates and their uncertainties derive from time series data of GNSS point positioning affected by ...
Building a Construction Project Key-Phrase Network from Unstructured Text Documents
(American Society of Civil Engineers (ASCE), 2017)
During a construction project lifecycle, an extensive corpus of unstructured or semistructured text documents is generated. The nature of unstructured sources impedes users' acquisition, analysis, and reuse of relevant ...
Auslegung von Stahlbetonrahmentragwerken mit Ausfachungen aus Ziegelmauerwerk (Teil 1) / Design of reinforced concrete enclosures infilled with clay block masonry (Part 1)
(Bauverlag BV GmbH, 2018)
Within the scope of the joint European project INSYSME, the German partners developed two systems - IMES and INODIS - for improving the seismic behaviour of masonry infilled reinforced concrete frames. The purpose of both ...
Resistance of cold-formed built-up stainless steel columns - Part II: Numerical simulation
(Elsevier Ltd, 2018)
In parallel with an experimental investigation of the flexural buckling behaviour of built-up stainless steel columns presented in the accompanying paper (Dobric et al., submitted for publication), a detailed Finite Element ...
FE validation of the equivalent diameter calculation model for grouped headed studs
(Techno Press, 2018)
Existing design codes for steel-concrete composite structures give only general information about the shear connection provided by headed studs in group arrangement. Grouting of the openings in prefabricated concrete slabs, ...
Computation of Thermal-Stresses and Contraction Joint Distance of RCC Dams
(Journal of Thermal Stresses, 2013)
A new approach in 3D numerical modeling for unsteady phased thermal-stress analysis of a massive concrete hydraulic structure is presented. The temperature field is computed first, providing a drive for the unsteady, ...