Претраживање
Приказ резултата 61-70 од 223
Elastoplastic analysis of frame structures subjected to cyclic loading
(Serbian Society of Mechanics ; Faculty of Mechanical Engineering, University of Belgrade,Belgrade, Belgrade, 2017)
Elastoplastic and Damage Analysis of Trusses Subjected to Cyclic Loading
(Trans Tech Publications Ltd.,, 2015)
In the present paper, the Preisach model of hysteresis is extended to structural analysis of trusses damaged under cyclic loading in plastic range. Parameters for the Preisach model of cyclic plasticity are obtained from ...
Comparative buckling analysis and determination of the effective length factors using two numerical procedures
(Serbian Society of Mechanics ; Faculty of Mechanical Engineering, University of Belgrade,Belgrade, Belgrade, 2017)
Behavior of the frame structures in elasto-plastic domain
(Serbian Society of Mecahnics ; Faculty of Technical Sciences, Belgrade ; Novi Sad, 2015)
Two numerical models for nonlinear analysis of CFT columns
(Društvo građevinskih konstruktera Srbije, Beograd, 2018)
Prevođenje konkavnih kupola druge vrste u tridimenzionalne konstruktivne sisteme – prostorne rešetke
(Niš: Faculty of Architecture and Civil Engineering in Niš; Serbian Society for Geometry and Graphics (SUGIG), 2008)
Cilj istraživanja ovog rada je bio da se iznađu geometrijska rešenja za formiranje prostornih rešetki nad pravilnim poligonalnim osnovama, tako da se postigne prostorna struktura koja ispunjava zahteve rigidnosti datog ...
Problems of floor slab design in terms of capacity, safety and energy efficiency / Problematika projektovanja međuspratnih ploča sa aspekta nosivosti, sigurnosti i energetske efikasnosti
(Građevinski fakultet, Subotica, 2017)
This article provides information about the possibilities of design and construction floor slabs concerning three very important aspects: the capacity, safety and energy efficiency.Nowadays, in the Republic of Serbia ...
The bridge over the Danube by Beska, Serbia conception design, the purchased work on the international competition
(MASE, 2003)
The conception design of the bridge over the Danube by Beska near Novi Sad, presents the
purchased work on the international competition. According to the conditions of the competition the new bridge should be constructed ...
Linear transient analysis of spatial curved Bernoulli – Euler beam using isogeometric approach
(Serbian Society of Mechanics, 2021)
In this paper, linear transient analysis of spatial curved Bernoulli – Euler beam with circular cross – section formulated using isogeometric approach has been presented. The isogeometric approach is based on the concept ...
Imperfection sensitivity of plates on thermal environment
(Serbian Society of Mechanics ; Faculty of Mechanical Engineering, University of Belgrade,Belgrade, Belgrade, 2017)
In this paper a thermal buckling of imperfect plates using Layer Wise (LW) plate model [1] is presented. The model assumes layerwise variation of in-plane displacements and constant transverse displacement through the ...