Претраживање
Приказ резултата 31-40 од 180
Bending resistance of composite beams with nonductile shear connectors / Nosivost na savijanje spregnutih greda sa neduktilnim moždanicima
(Faculty of Civil Engineeirng, Subotica, 2018)
In this paper, the methods for determination of the bending resistance of composite beams with partial shear connection and nonductile shear connectors, according to Eurocode 4, are studied. The ...
Modalna analiza ramovskih konstrukcija primenom metode spektralnih elemenata
(Zbornik radova 13. kongresa DGKS, Zlatibor-Čigota, 2010)
Dinamička analiza ramovskih konstrukcija u frekventnom domenu ima niz
prednosti. Za gredne elemente mogu se primeniti spektralni elementi čija je
dinamička matrica krutosti frekventno zavisna, dobijena rešavanjem ...
An efficient beam-column element for nonlinear 3D frame analysis
(ECCOMAS Thematic Conference - COMPDYN 2011: 3rd International Conference on Computational Methods in, 2011)
A three-dimensional nonlinear beam-column element for the simulation of the global and local response of frames under monotonic and cyclic loading conditions is pre-sented. The element belongs to the group of concentrated ...
Conic Section of a Type of Egg Curve Based Conoid
(Belgrade: Faculty of Architecture in Belgrade; Serbian Society for Geometry and Graphics (SUGIG), 2010)
A cubic egg curve obtained by Hügelschäffer’s construction,
can be spatially interpreted as a plane section of a type of a conoid
set through a specially chosen 4-th order intersecting curve of two
quadrics: right ...
Computation of flow separations from bridge girders and effects on flutter derivatives
(Meteorological Institute, CEN, University of Hamburg, Hamburg, 2014)
The widely used formulation of aeroelastic forces presented in the work of Scanlan and Tomko (1971) relies on the frequency dependent coefficients - flutter derivatives and wind tunnel experiments as their identification ...
Accuracy Evaluation of Creep and Shrinkage Calculation Methods According to EC4
(4th International Conference Civil Engineering Science and Practice, Zabljak, 20. 2. 2012, 2012)
In the paper, the creep and shrinkage calculation methods for composite steel-concrete
beams are presented. The approximate methods AAEM, EM and methods according to
Eurocode 4, as well as, the exact method based on the ...
The Stiffness Matrix of the Fixed-End Composite Frame Element
(The 4th International Congress of Serbian Society of Mechanics, Vrnjacka Banja, Serbia, 4th June 2013, 2013)
The displacement method of frame analysis involves determination of the
element stiffness matrix. In the paper, the stiffness matrix of the fixed-end composite frame
element (type “k”) is derived. In general, the composite ...
Traditional materials as a solution to construction in the new age of climate distrubances
(Faculty Of Civil Engineering Subotica, 2019)
The paper contains the authors’ experiences and findings that were yielded as a result of measurements of the thermodynamic properties of traditional renewable materials. As a testament to the quality of existing traditional ...
Application of green roof for increasing the energy efficiency of the existing building in Belgrade
(Serbian Union of Mechanical and Electrical Engineering (SMEITS), 2019)
This paper presents the analysis of the potential use of green roofs to enhance the energy efficiency of the residential buildings. Namely, in urban areas, there is a lot of potential for reducing the energy needed for ...
Geometrical Characteristics and Solid Modeling of the Grasshopper Escapement Mechanism
(Faculty of Civil Engineering and Architecture ; Serbian Society for Geometry and Graphics SUGIG, Niš ; Beograd, 2014)
This paper presents the geometrical properties of one special type of escapement mechanism – the grasshopper escapement, by which the first marine chronometers were equipped. The most important and distinguish mechanical ...